Netgear Orbi satellite is a networking device that gives the best services. With the usage of Netgear Orbi you can boost the speed of your home network throughout the house. You can call it a home network booster or WiFi mesh system.

However, when users are going to install Netgear Orbi in their houses, they come across the Orbi pink light which shows that the satellite is out of sync.  To your knowledge, this issue occurs due to many possible reasons. If you are facing the same issue and want to know the suitable hacks to fix the issue, then you have come to the right place. Here, in this post, we are going to give some advanced troubleshooting tips so that you can solve the problem.

Well, first we would like to tell you about the contributing factors that cause this issue so that you can understand the issue properly and will be able to connect the Orbi satellite with the router hassle-free.

Why is Orbi Satellite Out of Sync?

There are many possible reasons why your Netgear Orbi is not connected to the router. All the reasons are mentioned below. You just need to walk through them to get familiarized.

Improper Power Supply

You can face this due to improper power supply. You need to make sure that you use the good condition power socket.

Excessive Distance Between Router and Satellite

If there is a long distance between the router and the Orbi satellite then it could also be the reason why the satellite is not synced.

Wrong Configuration

There is a possibility that you perform the wrong installation of your Orbi router and satellites as a result face the issues.

Firmware Outdated

If your Orbi system is running on old firmware version then you might not be able to connect the satellite to the router.

These are the contributing factors that you should know. You don’t need to worry about the reasons. After all, we have suitable solutions for you that will assist you. Keep reading!

Fix: Orbi Satellite Out of Sync

Here, we elaborate the advanced troubleshooting tips. You just need to walk through them and implement them properly.

Check the Power Supply

First, we start with this hack. You need to check the power sockets into which you plugged your devices. Make sure that the power sockets are non-damaged and give the fluctuation-free power supply to the router and Orbi.

If you found any fault on the cable then change it immediately.

Now, you should take a look at the Orbi color codes to make sure the Orbi pink light goes off or not. If not then don’t worry. Follow the next hack.

Bring the Device Close

If you make an excessive distance between the router and satellite then you need to reduce the distance between the devices. Due to the long distance, router and Orbi do not communicate properly and face connection issues. If you want to tackle this issue then you need to place the Orbi satellite near the router so that both devices are connected properly.

Verify the Configuration and Connection

You can face this issue due to faulty and wrong configuration. You need to make sure that you follow the proper steps or not. If you make a wired connection between the router and modem then check the Ethernet cable because sometimes due to a broken cable network does not travel properly through the cable. If you found any damaged Ethernet cable then you need to change the Ethernet cable.

Update the Firmware

If your Netgear Orbi runs on its old version then you need to update it fast. Old version of firmware does not support the features sometimes and creates the issue. So, we suggest you first check the firmware version by accessing orbilogin.com. If you found the old version then update it as soon as you can.

Restart the device

In case you are still in the same situation then you need to perform the simple restart process. There is a chance that your Orbi system becomes the victim of technical glitches. So, to remove the technical glitches you need to restart the device.

Therefore, these are the hacks that you need to perform to sync the router and Orbi satellite. In case you are not able to fix the issue, then you can perform the reset method.